Engine-related malfunction | |
Turn the ignition off and on | |
| |
If the fault persists, contact a specialist workshop without delay | |
Faulty ABS | |
During heavy braking the brakes may lock up | |
If the fault persists: | |
Drive carefully at a reduced speed and contact a specialist workshop without delay | |
The handbrake is engaged | |
or: | |
The brake fluid level is low | |
Release the handbrake | |
Refill the brake fluid | |
Contact a specialist workshop without delay | |
If the warning light flashes: | |
Faulty tyre pressure monitoring system (TPMS) | |
If the warning light remains illuminated | |
Low tyre pressure | |
Initialise the tyre pressure monitoring system | |
If the warning light flashes: | |
Check the tyre pressures | |
Adjust if necessary | |
The charging current is too low | |
The oil pressure is too low | |
Check the oil level | |
Top up if necessary | |
The seat belt is unfastened | |
Fasten the seat belt | |
The washer fluid level is too low | |
Top up the washer fluid | |
The fuel level is too low | |
Refuel the vehicle | |
Airbag system malfunction | |
If the warning light remains illuminated | |
The coolant temperature is too high | |
High coolant temperature | |
Stop the vehicle | |
Turn the engine off | |
Allow the engine to cool down | |
Wait for the fluid to cool down | |
Diesel engine preheating in progress | |
Wait until the warning light goes out | |
Start the engine immediately | |
Worn brake pads | |
High transmission fluid temperature | |
The transmission switches to limp home mode | |
Master warning light | |
The display shows a warning message | |
The rear fog light is on | |
Exterior light failure | |
Check all the exterior lights | |
Renew the faulty lights | |
The bonnet is open | |
Close the bonnet | |
The boot lid is open | |
Close the boot lid | |
Power steering failure | |
Master warning light | |
The service indicator shows the remaining km/time until the next service | |
The brake pedal should be pressed | |
Press the brake pedal | |
Automatic transmission: | |
When the accelerator pedal is used to hold the vehicle on an incline | |
The clutch assembly overheats | |
Press and hold the brake pedal | |