Процедуры ТО
AUDI A4 2.7 V6 TDI, 2008-2008, объем двиг.: 2698 см3, код двиг.: CAMB
- Заправочные жидкости: 13
- Заправочные объемы: 15
- Контрольные значения: 321
- Чертежи и схемы: 38
- Датчики подключения к двигателю: 47
- Местонахождения EOBD-разъемов: 1
- Процедуры ТО: 14
- Оглавления инструкций: 30
- Индикаторы приборной панели: 18
Процедуры ТО
- Automatic transmission: emergency park release
- Battery: procedures for disconnection/reconnection
- Service indicator reset
- Tyre pressure monitoring system
- Wheel alignment settings
- Windscreen wipers: service position
- Brake system: bleeding
- CVT: emergency park release, CVT, 0AW
- CVT: fluid level check and drain/refill, CVT, 0AW
- Electronic parking brake (EPB) procedures
- Keys and remote controls
- Maintenance schedules - Guidance
- Oil level check - Vehicles without dipstick, ( - 2011)
- Jacking and lifting points
- Oil temperature (°C):
- Ensure the vehicle is horizontal
- After engine oil renewal
- The oil pressure warning light illuminates
- Run the engine at idle speed
- Without pressing the accelerator pedal
- Wait for the light to turn off
- Turn the ignition off
- Wait for 5 minutes
- Check the oil level
- Oil level check:
- Method 1
- Select 'CAR -> Servicing and checks -> Oil level' from the menu
- Method 2
- Use a special tool:
- Oil level gauge
- Move the adjustment ring on the top scale
- The lower part of the ring must indicate the value
- Insert the gauge into the dipstick tube
- Read the value on the bottom scale
- Adjustment ring setting at the top of the scale
- Minimum oil level on the bottom scale
- Maximum oil level on the bottom scale
- Top up the oil if the bar in the display is close to 'min'
- Oil temperature (°C):
- Ensure the vehicle is horizontal
- After engine oil renewal
- The oil pressure warning light illuminates
- Run the engine at idle speed
- Without pressing the accelerator pedal
- Wait for the light to turn off
- Turn the ignition off
- Wait for 5 minutes
- Check the oil level
- Oil level check:
- Method 1
- Select 'CAR -> Servicing and checks -> Oil level' from the menu
- Method 2
- Use a special tool:
- Oil level gauge
- Move the adjustment ring on the top scale
- The lower part of the ring must indicate the value
- Insert the gauge into the dipstick tube
- Read the value on the bottom scale
- Adjustment ring setting at the top of the scale
- Minimum oil level on the bottom scale
- Maximum oil level on the bottom scale
- Top up the oil if the bar in the display is close to 'min'
- Oil temperature (°C):
- Ensure the vehicle is horizontal
- After engine oil renewal
- The oil pressure warning light illuminates
- Run the engine at idle speed
- Without pressing the accelerator pedal
- Wait for the light to turn off
- Turn the ignition off
- Wait for 5 minutes
- Check the oil level
- Oil level check:
- Method 1
- Select 'CAR -> Servicing and checks -> Oil level' from the menu
- Method 2
- Use a special tool:
- Oil level gauge
- Move the adjustment ring on the top scale
- The lower part of the ring must indicate the value
- Insert the gauge into the dipstick tube
- Read the value on the bottom scale
- Adjustment ring setting at the top of the scale
- Minimum oil level on the bottom scale
- Maximum oil level on the bottom scale
- Top up the oil if the bar in the display is close to 'min'