Процедуры ТО
CITROEN C4 Picasso 1.6 16V HDi FAP, 2011-2013, объем двиг.: 1560 см3, код двиг.: DV6C (9HR)
- Заправочные жидкости: 21
- Заправочные объемы: 21
- Контрольные значения: 276
- Чертежи и схемы: 14
- Датчики подключения к двигателю: 25
- Местонахождения EOBD-разъемов: 1
- Процедуры ТО: 12
- Оглавления инструкций: 26
- Индикаторы приборной панели: 25
Процедуры ТО
- Battery: procedures for disconnection/reconnection
- Brake system: bleeding
- Tyre pressure monitoring system
- Telematics emergency backup battery renewal
- Electronic parking brake (EPB) procedures
- Keys and remote controls
- Maintenance schedules - Guidance
- Self-levelling suspension: jacking up mode, 5 seats
- Self-levelling suspension: jacking up mode, 7 seats
- Semi-automatic transmission: fluid level check and drain/refill, MCP
- Service indicator reset
- Start/stop system: deactivation/activation
- The fluid level should be between MIN and MAX
- Raise the vehicle
- Connect the brake circuit bleeding device to the master cylinder
- Fill the reservoir
- Pressurise the system
- Pressure:
- Hydraulic reservoir bleeder:
- Close the circuit
- Follow the procedure:
- Open the front left brake caliper bleed screw
- Until no bubbles come out
- Close the bleed screw
- Collect the escaping fluid in a container
- Repeat the procedure
- Front, right
- Rear, left
- Rear, right
- Disconnect the brake fluid replacement unit
- Check the operation of the brake pedal
- After repairs:
- Bleed the secondary brake circuit
- Bleeding must be done with a diagnostic tool
- Brake fluid:
- Top up if necessary
- If required:
- Bleed the brake system
- The fluid level should be between MIN and MAX
- Raise the vehicle
- Connect the brake circuit bleeding device to the master cylinder
- Fill the reservoir
- Pressurise the system
- Pressure:
- Hydraulic reservoir bleeder:
- Close the circuit
- Follow the procedure:
- Open the front left brake caliper bleed screw
- Until no bubbles come out
- Close the bleed screw
- Collect the escaping fluid in a container
- Repeat the procedure
- Front, right
- Rear, left
- Rear, right
- Disconnect the brake fluid replacement unit
- Check the operation of the brake pedal
- After repairs:
- Bleed the secondary brake circuit
- Bleeding must be done with a diagnostic tool
- Brake fluid:
- Top up if necessary
- If required:
- Bleed the brake system